Numerical study on thermal performance of TiO2, Fe3O4 and NiCr/engine oil in an inclined wavy pip

The essential intention of the existing article is to illustrate the effect of wall properties on flow and thermal behavior, through a sinusoidal inclined wavy pipe. To succeed this phenomena we assume a sinusoidal pipe consist of wavy surface, whose walls traveling down to its borders and located at an inclined position, moreover titanium dioxide (TiO₂), ferrosoferric oxide (Fe₃O₄) and nichrome (80% Ni and 20% Cr) are considered as nano-particles and unused engine oil is assumed as a base fluid. The arising mathematical equations for thermal and flow ratio with wall slip impact are solved by mathematica. Also, evaluate graphically the thermal and flow behavior of nanofluids for multi values of solid volume fractions (η), rigidity parameter (M₁), stiffness parameter (M₂), viscous damping parameter (M₃), Grashof number (G_r), slip parameter (β) and heat generation parameter (H) also discuss the streamlines for different values of solid volume fraction.     

煤直接液化油中混合酚的分离研究

利用分子筛择形特点，对煤直接液化油中的混合酚实施高效分离。本研究选取间甲酚和对甲酚作为分离煤直接液化油馏分段混合酚的模型化合物，采用化学液相沉积法对HZSM-5吸附剂的孔口结构进行改变，分析分子筛硅铝比及颗粒粒径对模型化合物间甲酚和对甲酚吸附分离性能的影响，以获得高性能固相吸附剂，并将其应用于180-190℃馏分段混合酚分离。结果表明，当分子筛硅铝比为25、粒径为3-5 μm时，分子筛的孔口结构调节效果最优；当正硅酸乙酯的最小用量为0.2 mL/g时，固相吸附剂的吸附量为0.03 g/g，对甲酚选择性高于95%。由于外表面沉积物对吸附剂的孔口结构变化，导致对甲酚选择性的提高。进一步采用HZSM-5（1）吸附剂对真实煤直接液化油混合酚的分离中发现，苯酚和对甲酚的选择性均达到100%。     

Morphologically controlled synthesis of 1-dimensional selenium dioxide and study of its application as catalyst for diesel fuel additive

In this research work, selenium dioxide (SeO₂) nanorods have been prepared by a solvothermal method in which a strong reducing agent (NaBH₄) was used to reduce precursor salt into SeO₂ nanorods. X-ray diffraction (XRD) technique was applied to observe the crystal structure which confirmed its tetragonal geometry. Moreover, morphology and particle size were studied by scanning electron microscopy (SEM). SEM fully described the 1-dimensional morphology of SeO₂ nanorods which then arranged themselves to create a 3-dimensional flower-like structure with an average particle size of 50 nm. Also, the catalytic activity of SeO₂ nanorods as diesel-additive was studied by defining different parameters such as fire and flash points, calorific value, cloud and pour points, specific gravity, and kinematic viscosity. Subsequently, SeO₂ nanorods proved to be an excellent diesel additive due to higher total heat content and lower value of kinematic viscosity which enhances the better performance of the diesel engine.     

新疆野生黑加仑与马林果实的营养成分分析

通过对新疆野生黑加仑和野生马林的脂肪油，8种微量元素，17种氨基酸以及维生素C的含量进行测定得出：黑加仑脂肪油含量为17．9％，马林的脂肪油含量为22．3％，其中，黑加仑脂肪油中，r－亚麻酸的含量为19．02％，而马林中，其含量为9．40％，黑加仑中K，Na,Ca,Cu,Zn,Fe的含量比马林中的含量高，而Mn,Mg元素的含量却比马林含量低；马林的维生素C含量为16．22mg/g，黑加仑的含量为108mg/g，黑加仑的氨基酸的总量为1．63％，马林为1．14％。     

Feasibility study for the preparation of certified reference materials part I – mineral oil contaminated soils

The international joint project HYCREF (Contract No. G6RD-CT-2002-00854), funded by the European Commission in the 5th Framework programme, aimed to develop methods to prepare homogeneous and stable reference materials of water, soil, and waste contaminated with mineral oil hydrocarbons and to certify the mineral oil content by gas chromatographic methods. The results of a feasibility study for the preparation of three soil reference materials are discussed in this paper, and for the preparation of three waste reference materials in the second part (Koch et al., Accred Qual Assur submitted for publication). The soil materials were selected to represent different soil types and contamination levels. The project plan set three requirements for these reference materials: uncertainty in the mineral oil content resulting from the certification exercise <5%, a sample inhomogeneity of <3% and a minimum long-term stability of 5 years. For the most part, these requirements were met within this project.     

A RAPID APPROXIMATION FOR PREDICTING THE HYDROCARBON DISCOVERY RATE: PART 1. ASSESSING THE ACCURACY

The hydrocarbon discovery prediction problem is important to firms having to make decisions about the deployment of scarce exploration resources. Traditional methods for estimating the discovery rate rely on the completion of time consuming simulation experiments. A rapid approximation that does not require the completion of simulation exists and has been shown to have some promise as a prediction tool. This paper investigates the accuracy of the approximation method under a wide variety of distributional and drilling efficiency assumptions. The results indicate that the approximation produces predictions close to those of simulation under most of the tested conditions. This suggests that resource exploration firms could conveniently use the method for a wide variety of planning purposes without incurring the same costs in time and personnel required for simulation.     

用^60Co放射源检测油垢厚度的初步实验研究

本文用石蜡模拟油垢，用^60Co放射源的1．25MeV平均能量的γ射线垂直入射，以一定的散射角和不同的探测立体角接收散射γ光子敫．发现散射γ计数与被测石蜡厚度之间存在不同的线性关系．结果发现，放射源与探测器之间屏蔽的好坏和合理的探测距离对提高线性度有很大关系．本实验测得最佳线性相关系数平方值为0．9981，平均测量精度为1．26mm．这对研究散射法检测油垢厚度和选择合适的探测距离提供了实验基础．     

油价波动对国民经济影响模型构建与应用

为了科学构建原油价格波动与国民经济发展的关系,在借鉴国内外专家学者相关模型基础上,考虑不同国民经济指标对油价波动的时滞反馈等因素,构建油价波动对国民经济影响模型.利用原油价格波动对国民经济发展的动态模型,对模型的各部分关系系数进行确定,最后根据所得到的模型对国民经济影响进行实际分析与预测,并得出规避油价波动影响风险的措施.     

Limonene concentration in lemon (Citrus volkameriana) peel oil as a function of ripeness

The dependence of the limonene content of lemon (Citrus volkameriana) peel oil on the degree of ripeness of the fruit has been studied by using steam distillation and cold pressing to extract the oils from lemon fruit peel at different stages of maturation (green, greenish-yellow, and yellow-orange peel coloration). Samples of essential oils were analyzed by high resolution GC and GC-MS, using tetradecane as internal standard for quantitation. Forty components were detected; thirty eight were positively identified by comparison of their mass spectra (El, 70 eV) and Kováts retention indexes (determined using a non-logarithmic scale on capillary columns coated with both polar (DB-Wax) and non-polar (DB-1) stationary phases) with those of standards and with data reported in the literature. The limonene concentration reached a maximum level of 79.4% when the fruit was in the intermediate maturation stage characterized by greenish-yellow coloration.